Monday, 20 February 2017

Amas - half glassed

One-ounce glass mat with unwaxed polyester resin:


So starboard sides are done. Probably will do an extra layer on the bottoms. Also extra where the akas will attach, then some filled resin over all.



Sunday, 19 February 2017

Amas - filled & faired

I am so "sick up and fed" with filling and sanding! I no longer care how smooth the final product is! I think I should have put some filler in the first coat of resin that I sealed the foam with. That would have made the process much easier. As it was, I was sanding filled resin and unwaxed resin both. The unwaxed resin rolls off and clogs the sandpaper; filled, it sands well. (Using polyester resin.)

For filler, I used half micro balloons and half magnesium silicate (talc).

Anyway, I'm done now. I put together a little cradle out of some foam scraps, so that the hulls wouldn't move around while I'm glassing them:


John has suggested that I glass half at a time, from centreline around to centreline, so that there's an overlap along the centre, making somewhat of a spine for added strength and stiffness. Sounds like a good idea to me!



Friday, 3 February 2017

Amas - final shaping

It's been a long road, it seems, but now I have two hollow foam hulls that are more or less the same shape. The curve of the top has been an interesting exercise:
The nubs are the outsides of the flats that the akas will attach to. I had no idea they'd come out looking like this. I just knew I wanted enough of a flat on the top to secure the akas firmly to.
Holey foam!
The top radius started as a knife-cut angle which was then rounded with coarse sandpaper, followed by finer sandpaper. It feels like the same kind of process that a sculptor engages in: you take away everything that isn't the end result you're looking for. I did make a template for the top curve, but it turned out to be not quite right—so most of it is eyeballed. The ends are tricky, because everything changes as the hull gets narrower.

BTW—it was snowing as I was doing this!



Wednesday, 1 February 2017

Amas - last peek inside, shaping

Here's a last look at the inside of one of the amas before top & bottom were glued together:
 The upper one above is the top half of the ama. After a straight-sided channel was routed on the underside of the deck, the corner was cut off with a utility knife to make the bevel. Trying to get rid of as much foam as practical. The bottom didn't get routed at all.
Top half is at left above.

. . .

The amas are now single pieces, complete hulls. Here, one has been shaped, the other awaits the sandpaper:
 The corners were rounded with coarse sandpaper by hand. A sanding machine at this stage takes off too much material. One needs to go slowly.
I could probably spend a couple more hours on the shaping, as there always seems to be a little hump here or there to smooth out. We'll see how much patience I have for that...